Surface decoration: what each finish actually does
Silk screen, offset, hot stamping, UV metalizing, soft-touch. What each process is good at, what it costs, and where it fails.

Decoration is where a packaging budget is usually either spent well or wasted. The same bottle can carry a two-colour screen print or a six-colour offset with hot stamp and soft-touch coating, and the difference in unit cost is larger than the difference in perceived value if the finishes fight each other.
Silk screen
Screen printing lays a thick ink film, which makes it the most opaque option on coloured and dark substrates. It is excellent for solid brand marks and short text, and it is durable through handling and alcohol contact.
It cannot hold fine halftones or small reverse-out type. Above three colours, cost rises quickly because each colour is a separate pass.
Offset printing
Offset gives fine detail, smooth gradients and photographic reproduction. On tubes and oval bottles with a flat decoration panel it is the right choice for complex artwork.
On a strongly curved surface, offset distort at the edges unless artwork is pre-distorted for the cylinder. This is normal, but it must be handled at artwork stage rather than discovered at proof.
Hot stamping
A heated die transfers metallic foil into the surface. It reads as premium because the metal is real and catches light, unlike a metallic ink.
Foil adheres best to smooth, hard surfaces: PETG, acrylic, coated tubes. On soft-touch coatings, adhesion must be tested — the foil can lift at the edges after abrasion. Hot stamp tooling is a per-artwork cost, so it suits a design that will run for several seasons.
UV metalizing
Vacuum metalizing deposits a thin aluminium layer, then a tinted topcoat produces the colour. It gives a full-surface mirror or satin metal effect at a fraction of the cost of metal components.
The weakness is abrasion: a metalized surface scratches, and it shows fingerprints. A protective topcoat helps, and matte metalized finishes hide wear better than high gloss. Metalized parts are also not recyclable in plastic streams, so they conflict with a mono-material claim.
Spray coating and soft-touch
Spray coating delivers an even colour over a complex shape and can add a matte, satin or rubberized feel. Soft-touch is a two-component polyurethane coating with a low-friction surface that feels premium in the hand.
Soft-touch is the finish most likely to cause complaints: it marks with oily hands, it scuffs in transit, and it can yellow under UV. It is appropriate for a premium launch in a secondary carton, less appropriate for a product that travels loose in an e-commerce parcel.
Choosing a combination
A workable rule: one structural finish (colour, coating or metalizing) plus one graphic process (screen, offset or hot stamp). Two structural finishes plus two graphic processes is where cost outruns value and where adhesion failures appear.
Whatever the combination, approve a physical sample on the production substrate and test it: a rub test with alcohol, a tape-pull test on the print edge, and a week in a warm carton. Most decoration failures are visible in that week.

Where to go next
Decoration is quoted per surface and per pass. The options we run are listed under customisation, and examples of metallised and matte finishes are in the full product range.
Specifying this for a real product? Send the drawing or a reference sample.



